W 03/07/17 08:24:11 00732 chassis: PoE controller 6 selftest failure.
Other fault auto low at 8023af.1.
If the reserved PoE power is greater than 20 of bruno beltrami casino the total PoE power, the power capacity of the device is affected.At this time, the system has not calculated and found that the total power consumption exceeded the upper threshold; therefore, the system does not cut off power low-priority interfaces in time.To set the maximum output power of a board, run the poe max-power command.Then ran show logging -r -w : - Reverse event Log listing: Events Since Boot.The POE GUI screen showed all ports searching but no devices found or powered.If the maximum output power is not set, the available PoE power is the power provided by the PoE power module.The power consumption of a PD mindestalter casino bregenz keeps changing when the PD is running.Precautions, the reserved power should not be set greater than.Total Failover Power : .
Connected to CLI and ran show power-over-ethernet : Status and Counters - System Power Status.
Other fault auto low at 8023af.
If interfaces have the same priority, the system powers off the PD on the interface with a larger port number.Adding this in hopes that it helps someone else.W 03/07/17 08:24:09 00732 chassis: PoE controller 4 selftest failure.We got a NBD Limited Lifetime warranty replacement switch after working with HPE Support to resolve the issue.Internal Power 1 0W /.External Power, ePS1 /Not Connected.Support- show port inlinepower, port Type Oper Admin Priority Class Power Power PD Power Power (truncated) Status Status Limit Usage Type Capab- Capab (mW) (mW) ility Select.1.M 03/07/17 08:23:44 03002 system: System reboot due to Reset Switch.In this case, the board calculates the reserved power based on the set maximum output power.Sometimes, however, the power consumption increases sharply and the available power of the system cannot support the burst increase of power.Usage Scenarios, the device can dynamically allocate power to each interface according to the power consumption of each interface.
The switch itself was powered on and accessible for me to see the error but none of our WAPs connected to this switch were online.
So if you have the "PS Status: Power Supply alert 0 alert" showing in your GUI for a switch, check your POE to make sure you don't have a real issue with the internal power supply failing.
Then the system has time to power off interfaces of low priority to ensure stable running of other PDs.